Power failure - Emergency door
release
With a short power failure:
The program remains in the last position,
and when power is restored the following
message appears in the display:
PROGRAMME 1 COTTONS
PROGRAMME STOP
THROUGH POWER CUT
Please press the Start button.
^
Press X "Start", to continue the program.
With an extended power failure:
^
Turn off the machine.
^
Switch off the main power supply at the
wall switch.
^ Turn off the on site water or steam valves.
To remove the laundry the drain valve will
need to be opened manually and the drum
door unlocked manually.
^
Open the drain valve by partially opening
the venting screw.
^
Use a wrench at the rear of the machine,
but do not unscrew completely. Drain off
the suds.
^
Be careful, some water will seep out of the
screw opening. Catch water in a suitable
container.
^
Tighten up the venting screw and check
that there is no leak.
^
First position the screwdriver in the
opening, push in and hold firm.
^
Press against the door handle with your
right hand, and then pull on the door hand
-
le to open the door.
Never use force to open the door.
^
Take out the laundry.
Problem solving guide
22
To Next Page
Loading...
