What to do if...
80
The following fault messages appear in the display and the
programme stops
Issue Cause and remedy
Water intake See
The water inlet is blocked or restricted.
Check whether the stopcock is opened properly.
Check whether the inlet hose is kinked.
Check whether the water pressure is too low.
The filter in the water inlet is blocked.
Clean the filter.
Drainage See
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum delivery head is 1 m.
Service
Waterproof
The water protection system has reacted.
Close the stopcock.
Call Service.
Service Fault F
There is a fault.
Start the programme again. If the fault message
appears again, contact your Miele dealer.
To switch off the fault messages: switch the washer-dryer off with the button.
To Next Page
Loading...
Need help?
General
