Need help?Do you have a question about the Mikrofill ETHOS 130 and is the answer not in the manual?
General specifications for the ETHOS range of boilers, including dimensions and electrical data.
Details the heating input, output, and gas consumption for the ETHOS boilers.
Properties related to flue gas temperature, pressure, and water characteristics.
Information on flue gas CO2, NOx levels, and efficiency ratings.
Liability and use of original parts for Mikrofill products.
Instructions for safe use by persons and compliance with regulations.
Contact information for assistance during installation or product failure.
Guidelines for proper installation and maintenance of Mikrofill products.
How the boiler control unit manages output based on demand and safety devices.
Lists the safety devices installed on the boiler for protection.
Describes the boiler's delivery status and initial checks upon receipt.
Instructions regarding the removal of packing after transportation.
Guidance on handling and moving the boiler safely using technical data.
Information on boiler dimensions for doorway access during transport.
Requirement for installation by competent installers following national/local standards.
Guidance on selecting installation area and mounting procedures for various wall types.
General guidelines for boiler installation, including frost protection and clearances.
Requirements for ventilation, gas, water, and electrical connections.
Diagram and pinout details for the main PCB of the boiler.
Diagram and pinout details for the control fascia PCB.
Diagram and pinout details for external controls connected via DIN rail.
Types of flue systems (room sealed, open flued) and connection requirements.
Materials and installation guidelines for flue gas and air inlet pipes.
Instructions for the correct orientation of the flue adaptor during installation.
Table of flue gas data including temperature, quantity, and resistance for ETHOS boilers.
Factors influencing back pressure and cooling of flue gases.
Guidance on calculating flue system diameter and length.
Table showing resistance values for different flue components and systems.
Guidelines for condensate pipe installation and material requirements.
Requirements for the discharge pipe of the safety valve.
Required water circulation and flow rates for the boiler.
Information on pump flow rate, head, and power consumption.
Details on valves, flow protection, pressure, expansion vessels, and water quality.
Guidelines on water temperature, quality, and hardness for optimal system performance.
How the boiler operates, including fan control and output modulation.
Overview of the boiler control panel buttons and display elements.
Explanation of symbols used on the Printed Circuit Board (PCB).
Step-by-step guide to turn the boiler on.
Four methods for safely switching off the boiler.
How to use the display, control DHW/Heating, and view parameters.
How to access and navigate the boiler's history mode.
List of error codes, their descriptions, and resolution steps.
Continuation of error codes, descriptions, and resolution steps.
Requirements for commissioning by qualified personnel and initial checks.
CO2 and CO values and AT for checking at maximum load.
CO2 and CO values for checking at minimum load.
Procedure for adjusting the boiler's maximum load settings.
Procedure for adjusting the boiler's minimum load settings.
How to set and check CO2 values at maximum and minimum load.
Steps for converting the boiler from natural gas to propane.
Procedure for auto-detecting cascade structure and confirming burner count.
Procedure for testing all slave boilers in a cascade system.
Safety precautions to be taken before and during maintenance procedures.
Recommended frequency and procedures for annual boiler servicing.
Step-by-step instructions for removing the gas valve and venturi assembly.
Instructions for removing the fan and burner assembly for ETHOS 70 models.
Instructions for removing the fan and burner assembly for ETHOS 90, 110, 130 models.
Step-by-step guide for removing the pump and its head.
How to set and check the gaps for ignition electrode and ionisation probe.
List of casing and electrical components with part codes for ETHOS 70-130.
Exploded view and part list for core components of the ETHOS 70 boiler.
Exploded view and part list for core components of ETHOS 90, 110, 130 boilers.
Formulas for calculating fuel efficiency for non-condensing boilers.
Formulas for calculating fuel efficiency for condensing boilers.
General| Model | ETHOS 130 |
|---|---|
| Category | Boiler |
| Heating Capacity | 130 kW |
| Fuel Type | Natural Gas |
| Operating Pressure | 6 bar |
To Next Page
