Need help?Do you have a question about the Mikrofill Ethos Series and is the answer not in the manual?
Details on nominal heat input/output, and maximum gas consumption for different gas types.
Explanation of air/gas mixing, burner operation, and heat exchange within the boiler.
Lists and explains the various safety devices installed in the boiler.
Requirement for installation by a competent installer following national and local standards.
Details on gas connection location, isolation valves, and required gas pressures.
Requirements for competent installers, power supply, and EMC directives.
Guidelines for flue system installation, types, and permissable draught.
Minimum water circulation requirements and pump control operation.
Requirements for circulation pumps, cylinder type, and system layout.
Step-by-step guide on how to start the boiler.
Details the four methods for safely switching off the boiler.
A comprehensive list of boiler parameters, their index, and units.
Lists common error codes, their descriptions, and recommended resolutions.
Requirements for qualified personnel and pre-operation checks.
CO₂ values for maximum load for different gas types and models.
CO₂ values for minimum load for different gas types and models.
Procedure for adjusting the boiler to maximum load using the control panel.
Procedure for adjusting the boiler to minimum load using the control panel.
Guidance on adjusting CO₂ values at maximum and minimum load.
Instructions on using the flue gas tapping for analyser probe insertion.
Introduction to setting up multiple boilers in a cascade arrangement.
Process for auto-detecting cascade structure and confirming burner count.
Procedure to test firing of all slave boilers in a cascade setup.
Guidance on checking and adjusting ignition electrode and ionisation probe gaps.
To Next Page
General
