MikroTik AP User Manual

7. Open the VCI Staging Application. The below screen will load. If no Available Networks
appear then press “SCAN FOR WI-FI NETWORKS”.
NOTE: Available Networks will not show if Location Services is disabled or if devices
are not powered on. If the issue persist, try using a different 5GHz Android device
contact Support.
8. Connect to the Network Controller (NC) Wi-Fi by selecting the Available Network that
uses the last 6 digits of the WLAN number (circled below) on the back of the NC. Your 6
digits will differ from the ones shown below.

MikroTik AP Specifications

General

Brand	MikroTik
Model	AP
Category	Network Hardware
Language	English