MikroTik LHG kit Series User Manual (English)

To Next Page

LHG kit-series

This manual is for LHG kit series models:

LHG LTE6 kit (RBLHGR&R11e-LTE6)

LHG LTE kit (RBLHGR&R11e-LTE)

LHG LTE kit-US (RBLHGR&R11e-LTE-US)

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing

accidents.

Ultimate disposal of this product should be handled according to all national laws and regulations.

All installation methods for mounting an access point on any wall surface are subject to the acceptance of local jurisdiction.

The Installation of the equipment must comply with local and national electrical codes.

This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the

correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for people and damage to the system.

Use only the power supply and accessories approved by the manufacturer, which can be found in the original packaging of this product.

Read the installation instructions before connecting the system to the power source.

We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your

own risk!

In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.

It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling

requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.

This is a class A device. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate

measures.

Exposure to Radio Frequency Radiation:This MikroTik equipment complies with the FCC, IC, and European Union radiation exposure limits set forth for an

uncontrolled environment.This MikroTik device should be installed and operated no closer than 130 centimeters from your body, occupational user, or the

general public.

Quickstart

The default configuration CPE RouterMode:

*WAN port is protected by a firewall and enabled DHCP client.

Need help?

Do you have a question about the MikroTik LHG kit Series and is the answer not in the manual?

MikroTik LHG kit Series Specifications

General

CPU core count	1
Size of RAM	64 MB
Storage size	16 MB
Storage type	FLASH
PoE in	Yes
PoE in input Voltage	11-30 V
Number of Ethernet ports	1
Interface	Ethernet
Operating System	RouterOS
Architecture	MIPS
Ethernet ports	10/100 Mbps
Category	Wireless Access Point