LHGG LTE6 kit(RBLHGGR&R11e-LTE6)
Quickstart
1. Open the Ethernet port door;
2. Insert the SIM card into the slot, with the chip facing UP;
3. Connect the device to the included PoE injector with Ethernet cable to the data+power end;
4. Connect the data end of the PoE injector into the computer;
5. Connect the power adapter to the PoE injector;
6. Open thehttps://192.168.88.1in your web browser;
7. User name:admin, and there is no password;
8. Enter the PIN code, if required by your mobile network operator;
9. Use the check for update option to upgrade the device to the latest version. You must have an active
SIM card with available data;
10.The device will reboot;
11.Connect again and intheQuickSetmenuset a strong password.
Case assembly
1. Attach the two legs to the LHG case by sliding them onto the respective sides, legs are different and
cannot be exchanged (when looking at the product place it that cover for Ethernet port is in front of
you, leg marked R is for the right side, leg marked L is for the left side).
2. Snap the assembled LHG unit to the grid in the appropriate central location.
3. Fix the two legs in place with included two self thread screws (Phillips screwdriver PH2).
The package also contains a grounding cable connector and a 5-degree angle adapter, for easier up or
downward tilt adjustment.
Opening the case cover
Optional - to access the miniPCIe slot, the opening of the unit top cover is required. As an opening tool,
you can use a large size flat head screwdriver or a small coin. Be extremely cautious when opening,
because the incorrect opening of the clip can break it off!
Mounting and configuration of this device should be done by a qualified person.
Follow these steps:
To Next Page
Need help?
General
