1.
2.
3.
4.
LDF 5-series
LDF 5, LDF 5 ac
The LDF (Lite dish feed) is an outdoor wireless system with a built-in antenna, meant to be installed on satellite offset dish antennas.
Assembly
The device is compatible with standard offset dishes, commonly used for satellite television. The offset mount is universal at 40 mm diameter, and the LDF
can easily be placed inside it. To attach the Ethernet cable to the LDF unit, follow these steps:
Assemble all components as shown in the illustration. If using pre-made cables, cut the rubber seal on one side, to put it onto the cable. Self
crimped cables should be crimped after the seal is on the cable;
Connect Ethernet cable to Ethernet connector on LDF;
Attach Housing nut to LDF body by rotating clockwise;
Slide rubber seal into housing nut, then seal the waterproof gland by turning compression nut clockwise.
Assembling on dish
To Next Page
Need help?
General
