RB4011iGS+RM
RB4011iGS+RM
The device is already configured with basic settings, you can simply plug in your ISP cable and start using the Internet.
We recommend you set up a password to secure your device.
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with
standard practices for preventing accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This unit is intended to be installed in the rackmount. Please read the mounting instructions carefully before beginning
installation. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to
people and damage to the system.
This product is intended to be installed indoors. Keep this product away from water, fire, humidity or hot environments.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original
packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this
product with care and operate at your own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug
from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels,
output power, cabling requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik devices must be
professionally installed.
Setup
Connect your Internet cable to the first port, and local network PCs to the other ports.
Choose your powering solution, please see the Powering section for possibilities.
Set your computer IP configuration to automatic (DHCP).
The default IP address from the local network is 192.168.88.1, open this address in your web browser to start the
configuration. The username is admin and there is no password.
We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version
to ensure the best performance and stability. The device needs to have an active Internet connection.
Set up a strong password for the device.
Powering
The power consumption under maximum load can reach 33 W. The device accepts power from the power jack or from
the first Ethernet port:
Direct-input power jack (5.5 mm outside and 2.1 mm inside, female, pin positive plug) accepts 12-57 V DC.
The First Ethernet port accepts Power over Ethernet 18-57 V DC.
Connecting to a POE Adapter:
To Next Page
Need help?
General
