MikroTik hEX RB750GR3

To Next Page

hEX

hEX is a powerful five port Gigabit Ethernet router for locations where wireless connectivity is not required.

First use

1. Choose your powering solution, please see Powering section for possibilities.

2. Connect your Internet cable to port 1 (labeled “Internet”), and local network computers to ports 2-5.

3. Connect your direct input power jack if not using POE, to start up the device.

4. If using POE please see section POE Adapter on how to connect.

5. The device will boot up and after short beep, the network will be available for connecting.

6. Set your computer IP configuration to automatic (DHCP).

7. Once connected to the network, open http://192.168.88.1 in your web browser to start configuration, since

there is no password by default, you will be logged in automatically.

8. We recommend clicking the “Check for updates” button and updating your RouterOS software to the latest

version to ensure the best performance and stability.

9. Set up your password in the screen that loads.

Mounting

This device is designed for use indoors by placing it on the flat surface or mounting on the wall, mounting points are

shown on the picture below, screws are not included in the package. Screws with size 4x25 mm fit nicely,

depending on your wall structure you can use dowels 6x30 mm and 6 mm drill bit if needed.

When mounting on the wall, please ensure that cable feed is pointing downwards. We recommend using Cat6

cable for our devices. The IP rating scale for this device is IPX0.

See mikrotik.com/products for the latest version of this document. Document #49563 Modified on: 01.OKT.2019

Need help?

Do you have a question about the MikroTik hEX RB750GR3 and is the answer not in the manual?

MikroTik hEX RB750GR3 Specifications

General