MikroTik hEX User Manual

hEX
hEX is a powerful five port Gigabit Ethernet router for locations where wireless connectivity is not required.
First use
1. Choose your powering solution, please see Powering section for possibilities.
2. Connect your Internet cable to port 1 (labeled “Internet”), and local network computers to ports 2-5.
3. Connect your direct input power jack if not using POE, to start up the device.
4. If using POE please see section POE Adapter on how to connect.
5. The device will boot up and after short beep, the network will be available for connecting.
6. Set your computer IP configuration to automatic (DHCP).
7. Once connected to the network, open http://192.168.88.1 in your web browser to start configuration, since
there is no password by default, you will be logged in automatically.
8. We recommend clicking the “Check for updates” button and updating your RouterOS software to the latest
version to ensure the best performance and stability.
9. Set up your password in the screen that loads.
Mounting
This device is designed for use indoors by placing it on the flat surface or mounting on the wall, mounting points are
shown on the picture below, screws are not included in the package. Screws with size 4x25 mm fit nicely,
depending on your wall structure you can use dowels 6x30 mm and 6 mm drill bit if needed.
When mounting on the wall, please ensure that cable feed is pointing downwards. We recommend using Cat6
cable for our devices. The IP rating scale for this device is IPX0.
See mikrotik.com/products for the latest version of this document. Document #49563 Modified on: 01.OKT.2019

MikroTik hEX Specifications

General

RAM	256 MB
Storage	16 MB Flash
Operating System	RouterOS
Dimensions	113 x 89 x 28 mm
Max Power Consumption	10 W
Operating Temperature	-40°C to 70°C
PoE in	No
PoE out	No
Ethernet Ports	5 (10/100/1000)
USB Port	1 (USB 2.0)
Power Input	8-30V

Summary

First Use

Powering and Connection

Connect internet to port 1, local network to ports 2-5, and power up.

Initial Configuration Access

Device boots, set IP to DHCP, access via http://192.168.88.1 and set password.

Mounting

Mounting Options and Hardware

Designed for indoors, flat surface or wall mounting with specific screw sizes.

Powering

Power Sources

Device accepts power from DC jack (8-30V) or first Ethernet port (Passive PoE).

Booting Process

RouterOS Configuration

Explore configuration options via http://mt.lv/help or Winbox tool.

Extension Slots and Ports

Ethernet Ports

Buttons and Jumpers

Reset Button Functions

Describes functions for resetting configuration or network boot.

Mode Button

Connecting to a POE Adapter

POE Adapter Connection Steps

Operating System Support

RouterOS Version Support

Federal Communication Commission Interference Statement

FCC Compliance