First steps:
Connect the device to the included PoE injector with Ethernet cable to the data+power end;
Connect the data end of the PoE injector into the computer;
Connect the power adapter to the PoE injector;
Download WinBox configuration tool https://mt.lv/winbox;
Default IP: 192.168.88.1, user name: admin and there is no password, for the paired models, please find
the password on the sticker;
Set an IP address of your computer to 192.168.88.2;
In case the IP connection is not available, please use the Neighbors tab and connect through MAC
address;
Once connected configure the device, so it has an active Internet connection https://mt.lv/configuration;
Upgrade the RouterOS software to the latest version https://mt.lv/upgrade;
Choose your country, to apply country regulation settings;
Secure your device and set a strong password;
For more configuration information, please
visit https://wiki.mikrotik.com/wiki/Manual:Interface/W60G;
wAP60G AP units come pre-configured with WISP Bridge default configuration;
Wireless Wire and wAP60G units come pre-configured with PTP Bridge default configuration;
Wireless Wire devices have already, randomly generated, matching SSID, and Wireless passwords.
Safety Information:
Before you work on any MikroTik equipment, be aware of the hazards involved with electrical
circuitry, and be familiar with standard practices for preventing accidents. The installer should be
familiar with network structures, terms, and concepts.
Use only the power supply and accessories approved by the manufacturer, and which can be found in
the original packaging of this product.
This equipment is to be installed by trained and qualified personnel, as per these installation
instructions. The installer is responsible for making sure, that the Installation of the equipment is
compliant with local and national electrical codes. Do not attempt to disassemble, repair, or modify the
device.
This product can be installed both indoors and outdoors. Please read the mounting instructions
carefully before beginning installation. Failure to use the correct hardware and configuration or to
follow the correct procedures could result in a hazardous situation for people and damage to the
system.
To Next Page
Loading...
