Model FCC ID
RBwAPG-60ad TV7WAPG60AD
RBwAPG-60ad-
A
TV7WAPG60AD
RBwAPG-60ad-
SA
TV7WAPG60AD
M
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a commercial installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used
with the unit to ensure compliance.
This device is not to be operated on aircraft except for the conditions listed on FCC CFR §15.255 (b)
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC and IC
radiation exposure limits set forth for an uncontrolled environment. This MikroTik device should be
installed and operated no closer than 20 centimeters from your body, occupational user, or the general
public.
Innovation, Science and Economic Development Canada
Model IC
RBwAPG-
60adkit
7442A-WAPG60AD
RBwAPG-60ad 7442A-WAPG60AD
To Next Page
Loading...
