See www.routerboard.com for more information. Contact support@mikrotik.com for support questions. 1-Aug-2011
Buttons and Jumpers
RouterOS reset jumper hole (on the bottom of case, behind one of the rubber feet) – resets RouterOS software to
defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold
screwdriver in place until RouterOS configuration is cleared.
RouterBOOT reset button (RESET, front panel) has two functions:
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configu-
ration (same result as with RouterOS reset hole)
Hold this button during boot time longer, until LED turns off, and then release it to make RB750GL look for Net-
install servers.
Operating System Support
Currently tested operating system is MikroTik RouterOS starting from version v5.
Copyright and Warranty Information
Copyright MikroTikls SIA. This manual contains information protected by copyright law. No part of it may be reproduced or
transmitted in any form without prior written permission from the copyright holder. RouterBOARD, RouterOS, RouterBOOT
and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks appearing in this manual are the
property of their respective holders.
Hardware. MikroTik warrants all RouterBOARD series equipment for the term of fifteen (15) months from the shipping date
to be free of defects in materials and workmanship under normal use and service, except in case of damage caused by me-
chanical, electrical or other accidental or intended damages caused by improper use or due to wind, rain, fire or other acts of
nature.
To return failed units to MikroTik, you must perform the following RMA (Return Merchandise Authorization) procedure. Fol-
low the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA process.
1. If you have purchased your product from a MikroTik Reseller, please contact the Reseller Company regarding all
warranty and repair issues, the following instructions apply ONLY if you purchased your equipment directly from
MikroTik in Latvia.
2. We do not offer repairs for products that are not covered by warranty. Exceptions can be made for RB1000, RB1100
and RB1200.
3. Out-of-warranty devices and devices not covered by warranty sent to MikroTikls will be returned to the sender at
sender's cost.
RMA Instructions are located on our webpage here: http://rma.mikrotik.com
Manual. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not limited to,
the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made every effort to en-
sure the accuracy of the contents of this manual; however, it is possible that it may contain technical inaccuracies, typo-
graphical or other errors. No liability is assumed for any inaccuracy found in this publication, nor for direct or indirect, inci-
dental, consequential or other damages that may result from such an inaccuracy, including, but not limited to, loss of data or
profits. Please report any inaccuracies found to support@mikrotik.com
To Previous Page
Loading...
Need help?
General
