MikroTik RouterBOARD Groove 52HPn User Manual

See www.routerboard.com for more information. Contact support@mikrotik.com for support questions.
7-Dec-2012
• On e 10/100 Ethernet port, supportin g automatic cross/straight cabl e correction (Auto MDI/X), so you can us e either straight
or cross - over cable for connecting t o other network devices. The Ethernet port accepts 8 - 30V DC powering from a passive PoE
injector.
Buttons and Jumpers
• RouterOS reset jumper hole (no direct access, board has removed from case) – resets RouterOS software to
defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold
screwdriver in place until RouterOS configuration is cleared.
• RouterBOOT reset button (access through the plastic door) has two functions:
o Hold this button during boot time until LED light starts flashing,
release the button to reset RouterOS configuration (same result as with reset hole)
o Hold this button during boot time longer, until LED turns off,
then release it to make the device look for Netinstall servers.
Operating System Support
Currently tested operating system is MikroTik RouterOS (starting from version v5.0).

MikroTik RouterBOARD Groove 52HPn Specifications

General

Brand	MikroTik
Model	RouterBOARD Groove 52HPn
Category	Wireless Access Point
Language	English