1.
2.
3.
4.
wsAP ac lite
wsAP ac lite
The wsAP is a wall socket wireless access point. It is already configured, you can simply connect the Internet cable and start using wireless Internet. We
recommend you to set up a password to secure your device.
As with any MikroTik wireless access point, you can also manage it using the CAPsMAN wireless access point management server. In this case, all
configuration will be done in CAPsMAN. See Buttons and jumpers on how to set this device as a managed CAP.
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This unit is intended to be installed in the rackmount. Please read the mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.
This product is intended to be installed indoors. Keep this product away from water, fire, humidity or hot environments.
Use only the power supply and accessories approved by the manufacturer, and which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC, IC, and European Union radiation exposure limits set forth for an
uncontrolled environment.This MikroTik device should be installed and operated no closer than 20 centimeters from your body, occupational user, or the
general public.
Mounting
The device should be mounted on standard electrical wall boxes, where ethernet cabling has already been installed. The included mounting plate fits most
worldwide wall box standards. Orient the wall mounting plate on top of your wall box, and install the screws that fit your wall box screw holes the best.
Once the plate is in place, plug the required cables into the wsAP unit, and mount the unit on the mounting plate by putting it on the mounting hooks and
slightly pulling it downward, to secure in place.
Powering
The device only accepts powering at the E1 port with PoE, so you must either a passive PoE injector (not included), or make sure your switch supports
passive or 802.3af/at PoE output. The power consumption under maximum load can reach 8 W.
Setup
Connect your Internet cable to the E1 port.
Set your computer IP configuration to automatic (DHCP).
From your computer, connect to the wireless network name which starts with "MikroTik", or connect to the E2 ethernet port.
To Next Page
Need help?
General
