MikroTik wAP ac - User Manual

User Manuals
wAP ac , RBwAPG-5HacD2HnD
wAP ac BE, RBwAPG-5HacD2HnD-BE
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be
familiar with standard practices for preventing accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
The Installation of the equipment must comply with local and national electrical codes.
This unit is intended to be mounted on a pole, wall, or mast. Please read the mounting instructions
carefully before beginning installation. Failure to use the correct hardware or to follow the correct
procedures could result in a hazardous situation to people and damage to the system.
Read the installation instructions before connecting the system to the power source.
It is the customer's responsibility to follow local country regulations, including operation within legal
frequency channels, output power, cabling requirements, and Dynamic Frequency Selection (DFS)
requirements. All Mikrotik radio devices must be professionally installed.
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the FCC, IC, and
European Union radiation exposure limits set forth for an uncontrolled environment. This MikroTik
device should be installed and operated no closer than 20 centimeters from your body, occupational
user, or the general public.
Quickstart
 Make sure your Internet service provider is allowing hardware change and will issue an IP address.
 Open the bottom lid.

Summary

Safety Warnings

Exposure to Radio Frequency Radiation

Information on RF radiation exposure limits and safe operating distances for the device.

Mounting

Mounting on the mast or pole

Instructions for attaching the device to a mast or pole using included hardware.

Mounting unit on the wall

Steps for securely mounting the device onto a wall using brackets and screws.

Mounting on the ceiling

Guide for installing the device on a drop ceiling using a special bracket.

Bottom Lid

Procedure for securing the bottom lid with a captive screw for enhanced safety.

Powering

Connecting to a PoE Adapter

Step-by-step guide for powering the device using a Power over Ethernet adapter.

Expansion slots and ports

Configuration

Buttons and jumpers

Operating system support

Notice

Accessories

Federal Communication Commission Interference Statement

Innovation, Science and Economic Development Canada

Frequency bands terms of use

MikroTik wAP ac Specifications