3 - Add reagents in accordance with the Milestone Guide-
lines (suggested volume=10ml). Keep the safety shields
and springs in a safe place from droplets or acid fumes.
5 -Place the segment in the supplied worksta-
tion and use the torque wrench to tighten the
segment screw until the “click” sound of the key.
6 - Place the segment into the rotor plate and
close the door of the microwave cavity
4 - Introduce the PTFE vessel into the safety shield,
place the cover and the safety spring and place it into
the segment.
START USING YOUR SK-15 eT Rotor
1 - Remove the vessel from the rotor. 2 - Place the vessel on an analytical balance and
weigh the sample in accordance with the Mile-
stone guidelines (included in your USB key).
Quick Start Guides - ETHOS UP.indd 3Quick Start Guides - ETHOS UP.indd 3 25/09/20 16:3125/09/20 16:31
To Next Page
Loading...
