MILL SG2000MEC - Usage Mechanical Thermostat; Instructions Electronic Thermostat; Usage Electronic Thermostat

6 millnorway.com
EN
Usage mechanical thermostat
1. Set the output selector to the OFF position (0) and the thermostat to minimum. Plug
the heater into a grounded outlet.
2. Set the output selector to position I, II or III. Turn the thermostat up to the maximum
position. When the desired room temperature has been reached, turn the thermostat
slowly down until you hear a click. The thermostat can now remain in this position
until a different room temperature is desired. As soon as the room temperature falls
below this level, the heater will automatically switch on again. When the room has
again reached the desired temperature, the heater will switch off again.
3. If you wish to change the room temperature, repeat the instructions in step 2.
The heater has an overheat protection that turns the device off if any parts become
extremely hot.
5. To switch the heater off, turn the output selector to the 0 position. If the heater will
be left unused for a longer period of time, pull out the plug.
WARNING!-

ATTENTION! This heater is only meant to be used as a supplementary heating source,
and must not be used without supervision
Instructions electronic thermostat

Control panel
See gure 5 on separate illustration sheet
1. Thermostat, output selector and timer button (applies to CO2200LEDMAX only):
i. Turn the selector to the left to decrease the temperature, and turn the selector to
the right to increase the temperature.
ii. Push the button to change the desired power level. 3 power levels
iii. Press and hold the button for 3 seconds to activate the timer function, and

2. Fan ON/OFF (does not apply to CO2200LEDMAX).
3. ON/OFF button.
Power indicator — Shows whether the heater is using power or not.
5. Indicates the output level.
Indicates whether the fan is activated/timer indicator for the CO2200LEDMAX.
7. Desired room temperature.
8. Standby indicator for CO2200LEDMAX.
Usage mechanical thermostat
1. Plug the heater into a grounded outlet.
2. Press the ON/OFF button.
3. Choose the desired power I, II or III, by pressing the output selector. Turn the ther-