Before use
1) Make sure that the product is turned o and not plugged in.
2) Place the product on a rm and at surface, at least 60 cm above the ground, and at least 10 cm away from the wall.
As you need to ll the product with water at regular intervals, we recommend that you think carefully about where to
place the product, considering that water may be spilled on the furniture.
3) Fill the water tank:
A. Take out the water tank by liing it straight up (see the gure on the previous page)
B. Remove the screw cap (turn counterclockwise) on the boom of the water tank.
C. Fill the tank with cold water (Do not ll the tank with hot water because this can result in leakage)
D. Put on the screw cap and make sure that this ts well
E. Turn the water tank and put it back in the ultrasonic device (see the gure on the previous page)
F. The water tank will automacally deliver water to the unit.
4) Make sure the product is connected to regular mains (230 V), as indicated on the product label.
EN 4 millclimate.com
To Next Page
Loading...