MILL TH350 - Troubleshooting

Problem Cause Correcve measure
The unit is not working
The product is not receiving power Connect the plug to the socket and check
The product is not switched on Turn on the product
The light indicang empty water
tank is lit
Please ll the water tank with cold water
The steam produces an undesirable
odor
New machine
Unscrew the screw cap on the water tank and
leave the water tank open for 12 hours in a cool
place
Dirty water or water that has been
le in the water tank for a long
me
Clean the tank and ll it with clean, cold water
The control panel is lit, but the
product does not switch itself on
Too much water in the ultrasonic
unit
Disconnect the product from the energy source
and empty water from the ultrasonic unit
Less steam than usual The ultrasonic membrane is dirty Clean the ultrasonic-membrane with a small brush
(included). (The membrane is located in the middle
of the ultrasonic device and is shiny and round,
surrounded by a lot of material.)
Abnormal sound Resonance in the water tank when
the water level is low
Pour more water into the water tank
Abnormal sound The products is unstable Move the product to a rm and at surface
Troubleshoong
Please go through the troubleshoong guide to idenfy what can be done to correct the problem.
Contact Mill Internaonal AS should the problem persist.
EN 6 millclimate.com