Millarco 62.090 - Page 26

Balancing the Multi-tool on the Shoulder Harness
1.Hangthemachineontheharnesshook,andsee
how it balances.
2.Adjusttheshoulderstrap(8),theharnessattachment
on the engine extension tube and the shaft handle
(7) so the attachment head balances at the
required height.
Starting the product depends on whether the engine is cold or warm.
WARNING: The recoil starter can be damaged by abuse.
- Never pull the starter cord to its full length.
- Always engage the starter before cranking the engine.
- Always rewind the starter cord slowly.
Once the machine has been correctly assembled and setup for operation, start
the engine as follows:
1.Pressthefuelprimerbulb(6)8timesoruntilnoairbubblesareowing
through the primer bulb.
2. Turn the engine switch (9) in the on position
3. Move the carburettor choke lever (2) to the ‘on’ position.
4. Pull the recoil starter handle (4) slowly until it engages, then pull briskly.
 Repeatthisstepuntiltheengineresandstartsrunning.
5. Once the engine is warmed up after a few seconds, adjust the choke lever (2)
back to the ‘off’ position.
6. To control the engine speed, hold down the safety catch (10) on the shaft
handle (11) and pull the throttle trigger (12).
When re-starting a warm engine (that has already been running), choke
activation is not required.
Starting the product depends on whether the engine is cold or warm.
WARNING: The recoil starter can be damaged by abuse.
- Never pull the starter cord to its full length.
- Always engage the starter before cranking the engine.
- Always rewind the starter cord slowly.
Starting the multi-tool