Millarco 62.090 - Page 27

Once the machine has been correctly assembled and setup for operation, start
the engine as follows:
1.Pressthefuelprimerbulb(6)8timesoruntilnoairbubblesareowing
through the primer bulb.
2. Turn the engine switch (90 in the on position
3. Move the carburettor choke lever (2) to the ‘on’ position.
4. Pull the recoil starter handle (4) slowly until it engages, then pull briskly.
 Repeatthisstepuntiltheengineresandstartsrunning.
5. Once the engine is warmed up after a few seconds, adjust the choke lever (2)
back to the ‘off’ position.
6. To control the engine speed, hold down the safety catch (10) on the shaft
handle (11) and pull the throttle trigger (12).
When re-starting a warm engine (that has already been running), choke
activation is not required.
To Start a Flooded Engine
1. Disconnect the spark plug boot and use the spark plug wrench supplied to
remove the plug in a counter-clockwise direction.
2. If the spark plug is fouled or is soaked with fuel, clean or replace the plug as
required.
3. Turn the product so that the spark plug hole is aimed at the ground.
4. Clear excess fuel from the combustion chamber by cranking the engine
several times while the spark plug is removed.
5.Installthesparkplugandrmlytightenitwiththesparkplugwrenchsupplied.
 DONOTOVERTIGHTEN.
6. Reconnect the spark plug boot. Incorrect spark plug installation can result in
serious engine damage.
WARNING: Incorrect sparkplug installation can result in serious engine da-
mage. Stopping the Engine
1. Cool the engine by allowing it to run at idle for 2-3 minutes.
2. Slide the ON/OFF switch to the OFF position.
Follow these steps to operate the multi-tool:
1. Remove blade guard from the blade.
2. Start the multi-tool.
3.Holdthemulti-toolatwaistlevelwithyourrighthand
(arm extended) on the trigger handle and your left
hand on the front handle.
4. Place the product on the right side of your body
with the engine behind and away from your body.
5. Brushcut weeds and vines in a right-to-left motion
with the blade parallel to the ground.
Operating the multi-tool