4
Keypad door and circuit board can be re-
moved from the housing. To remove, make
sure that door is completely open and slide
it to the right while pulling away from the
control box.
Please remember to remove the door while
mounting the control box so that the circuit
board is always protected.
The keypad can be mounted to any
standard gooseneck stand using the
enclosed carriage bolts. If you have a
non-standard gooseneck mounting pat-
tern, you can use the enclosed steel
faceplate to modify for a correct fit.
The faceplate can also be used to
manufacture a custom gooseneck
stand.
MOUNTING INFORMATION
To Next Page
Loading...
General