6
To add Access Code 1934
To remove Access Code 1934
To add Flash Code 4437
(for one use only)
To add Latch Code 5501
To set relay output time 15
seconds (1/2 - 60 seconds)
To set relay output time 1/2
second
To change Master Code from
2580 to 1234
To clear all Access, Flash,
and Latch codes
To add Access Codes
2413, 8888, and 9743
(you may add up to 1000
different codes)
Model 950/951 Keypad Programming Manual
The very first time that you apply power to the keypad, you will hear a series of beeps followed by a regular repeating
beep (1 beep at 3 second intervals) that lets you know you are in programming mode.
Enter a 4 digit Master Code that only you will use for programming purposes. Write Master Code here ______________
You can now add up to 1000 access codes as well as a flash code (for use only once) and a latch code to hold open the
gate.
Example - Master Code 2580 beep - accepted
rejected
Master Code Sub Mode Access Code Exit
Master Code Sub Mode Access Code Exit
Master Code Sub Mode Access Code Exit
Master Code Sub Mode Flash Code
Master Code Sub Mode Latch Code
Master Code Sub Mode # Seconds
Master Code Sub Mode New Master Code Exit
Master Code Sub Mode
To Next Page
Loading...
General