2. Adjust the playback speed using [–] and [+] (setting range: 30 to 280 beats per minute).
The setting is automatically stored.
6.4 Selecting and adjusting drum kits
You can select one of the preprogrammed drum kits. The preprogrammed voices of the drum
module can be programmed to any of the connected pads.
To select a certain drum kit, proceed as follows:
1. Press [MODE] repeatedly until the [KIT] LED lights up.
ð
The display shows the kit number.
2.
Use [–] and [+] to select the desired kit (see
Ä
Chapter 11.2 ‘Kit list’ on page 41).
The setting is automatically stored.
1. Press [MODE] repeatedly until the [KIT] LED lights up.
ð
The display shows the kit number.
Selecting a drum kit
Adjusting kit volume
Operating
MPS-150
23
E-Drum Module