To programme a certain Voice for a pad, proceed as follows:
1. Press [MODE] repeatedly until the [VOICE] LED lights up.
2. Hit the respective pad to activate it.
3. Press [PAGE] repeatedly until the display shows the number of the currently assigned
Voice.
4.
Select the desired Voice using [–]/[+] (see
Ä
Chapter 11.1 ‘Voice list’ on page 38).
The setting is automatically stored.
Only Voices from group 1 – group 4 can be assigned to a Hi-Hat. The display shows
‘H-I’ .
Assigning a Voice
Operating
MPS-150
25
E-Drum Module
To Next Page
Loading...