Millenium slow stick x - Wing Assembly - Wing Tips and Shaping; Wing Tip Attachment and Shaping; Leading Edge Shaping and P1 Attachment

6
Step-16: Install DO NOT glue WT1 and
WT2.
Step-17: Glue wing tip assembly to W4 wing
tip. Be sure the trailing edge is straight with the
main wing trailing edge.
Step-18: Glue wing tip stiffeners WT4, WT5
and WT7 in place.
Step-19: Round-off leading edge and tip of
wing. Leave trailing edge flat, but sand flush
TE-A and TE-B.
Step-20: Sand 3/16 Square leading edge piece
flush with Part LE so that plywood part P1 sits
flat.
Step-21: Glue P1 in place.