Miller 216WLS - General Requirements, Warnings and Limitations

User Instructions - English
3
Questions?
CALL
1.800.873.5242
It is crucial that the authorized person/user of this fall protection equipment read and understand
these instructions. In addition, it is the employer’s responsibility to ensure that all users are trained
in the proper use, inspection, and maintenance of fall protection equipment. Fall protection training
should be an integral part of a comprehensive safety program.
Proper use of fall arrest systems can save lives and reduce the potential of serious injuries from a
fall. The user must be aware that forces experienced during the arrest of a fall or prolonged sus-
pension may cause bodily injury. Consult a physician if there is any question about the user’s ability
to use this product. Pregnant women and minors must not use this product.
Thank you for your purchase of Miller Fall Protection equipment. Miller brand products are pro-
ducedtomeetthehigheststandardsofqualityatourISO9001:2000certiedfacility.MillerFall
Protection equipment will provide you with years of use, if cared for properly.
Thank You
All persons using this equipment must read, understand and follow all instructions.
Failure to do so may result in serious injury or death. Do not use this equipment un-
less you are properly trained.
WARNING
All warnings and instructions shall be provided
to authorized persons/users.
All authorized persons/users must reference
the regulations governing occupational
safety, as well as applicable ANSI or
CSA standards. Please refer to product
labeling for information on specic OSHA
regulations, and ANSI and CSA standards
met by product.
Proper precautions should always be taken to
remove any obstructions, debris, material, or
other recognized hazards from the work area
that could cause injuries or interfere with the
operation of the system.
All equipment must be inspected before
each use according to the manufacturer’s
instructions.
All equipment should be inspected by a
qualied
person
on
a
regular
basis.
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
Equipment must not be altered in any way.
Repairs must be performed only by the
manufacturer, or persons or entities authorized
in writing by the manufacturer.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
discarded.
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have a rescue
plan and the means at hand to implement it
when using this equipment.
Never use fall protection equipment for
purposes other than those for which it was
designed. Fall protection equipment should
never be used for towing or hoisting.
All synthetic material must be protected from
slag,
hot
sparks,
open
ames,
or
other
heat
sources. The use of heat resistant materials is
recommended in these applications.
Never use natural materials (manila, cotton,
etc.) as part of a fall protection system.
1.0 General Requirements,
Warnings and Limitations