MADE IN THE USA.
WARNING:
MANUF ACTURER'S INSTRUCTIONS SUPPLIED WITH THIS PRODUCT
AT TIME OF SHIPMENT MUST BE FOLLOWED: F AILURE TO DO SO COULD RESUL T
IN SERIOUS INJUR Y OR DEA TH. CONT ACT MILLER FALL PROTECTION IF
INSTRUCTION
MANUAL IS NEEDED.
ADVERTENCIA:
DEBEN SEGUIRSE LAS INSTRUCCIONES DEL FABRICANTE
PROVIST AS CON ESTE PRODUCT O AL MOENT O DES DESP ACHO: EL NO HACERLO
PUEDE RESUL TAR EN LESIONES GRA VES O LA MUERTE. SI SE REQUIRE EL
MANUAL DE INSTRUCCIONES CONSUL TE CON MILLER F ALL PROTECTION.
AVERTISSEMENT :
VOUS DEVEZ RESPECTER LES INSTRUCTIONS DU FABRICANT
QUE VOUS AVEZ RECUES AVEC LE PRODUIT . DANS LE CAS CONTRAIRE. VOUS
RISQUEZ DES BLESSURES GRA VES OU MEME LAMORT . CONT ACTEZ MILLER FALL
PROTECTION SI VOUS AVEZ BESOIN D'UN NOUVEAU MANUEL.
CAUTION: INSPECT BEFORE EACH USE
PUNCH GRID ON DATE OF FIRST USE
J
YR
F M A M J J A S O N D
1
2
3
4
5
ö
Shock - Absorbing Lanyard
LB669 REV. C
1-800-873-5242
M.P.N. MFP9350362
CAUTION: INSPECT BEFORE EACH USE
DO NOT REMOVE THIS TAG
DATE:
MODEL\LENGTH:
MATERIAL:
:
CAP ACITY 310 LBS.
ANSI Z359.1, ANSI A10.32-2004,
EXPIRATION DATE: SEE MANUAL FOR INSPECTION
LANYARD
®
WARNING:
- CONNECT ORS AND ANCHORAGE POINTS MUST BE COMP ATIBLE AND ABLE
TO SUPPORT 5,000 LBS (22kN).
- RIG LANY ARD T O ALLOW A MAXIMUM FREE FALL DIST ANCE OF NOT MORE
THAN SIX FEET (6') [1.83m].
- DO NOT ALLOW LANY ARD T O CONT ACT SHARP OR ABRASIVE SURF ACES,
SP ARKS OR TEMPERA TURES ABOVE 180 DEGREES F. (82 DEGREES C.)
- SNAPHOOKS WITH GA TE OPENINGS LARGER THAN ONE INCH (1") [2.54cm] MUST NOT
BE CONNECTED TO D-RINGS ON HARNESSES AND BEL TS.
- REMOVE FROM SER VICE IF ANY DAMAGE IS DETECTED.
OSHA 1926.502, CSA Z259.1-95
IF USED FOR FALL PROTECTION, A SHOCK-ABSORBER, LIMITING THE FORCES
TO 1800 LBS. (8.01kN) OR LESS MUST BE USED.
REMOVE FROM SERVICE IF ANY DAMAGE IS DETECTED.
NEVER USE A STEEL CABLE LANYARD FOR FALL ARREST UNLESS USED IN
CONJUNCTION WITH A SHOCK-ABSORBER.
-
-
-
& HORIZONTAL or
VERTICAL LIFELINES
MILLER
To Next Page
Loading...
