* additional settings for C 1216 / C 1240 instruments
RANGE
Opens the selection list in which the size of the
display range can be selected. The increments of
the analog scale and the number format of the
numerical display are changed accordingly. The
following increments are available for the differ-
ent measuring units:
mm µm inch
10 10 000 0.3
3 3 000 0.1
1 1 000 0.03
0.3 300 0.01
0.1 100 0.003
0.03 30 0.001
0.01 10 0.0003
0.003 3 0.0001
0.001* 1* 0.00003*
0.0003* 0.3* 0.00001*
I — — — — — I I — — — — — I I — — — — — I
"I — — — — — I“ stands for “tolerance limited”.
This means that the display range depicts the
range between the lower and upper tolerance
limit. This can be used with the analog display to
quickly identify where the current measured val-
ue lies in the tolerance range. This enables trends
(e.g. ever larger dimensions) to be rapidly iden-
tified, enabling appropriate countermeasures to
be implemented.
As tolerance ranges vary, the letter-
ing of the analog scale (the numeri-
cal values) is removed.
The unit of measurement of the
display (mm, µm or inch) cannot
be changed with this key. If an al-
ternate unit of measurement is re-
quired for the display, this has to be
selected via the catalog of functions
and parameters under “SETTING”
--> “UNIT”. The current measuring
unit is indicated in the bottom line
of the display.
To Next Page
Loading...