Millimar C 1240 - User Manual

Mahr GmbH, Standort Esslingen, Reutlinger Straße 48, 73728 Esslingen
Tel. +49711 9312-600, Fax +49 711 9312-756 mahr.es@mahr.de, www.mahr.de
Operating Instructions
3723047
Millimar C 1208 /C 1216 / C 1240
08.11 .2016

Millimar C 1240 Specifications

General

Resolution	0.01 mm
Power Supply	24 V DC ±10%
Protection Class	IP40
Output Signal	RS-232
Operating Temperature	0 to 50 °C

Summary

Operating Instructions for Mahr Millimar C 1208;C 1216;C 1240

Critical Safety Instructions

General Safety Precautions

Essential safety guidelines for operating the instrument to prevent injury or damage.

Initial Commissioning and Setup

Basic Device Configuration

Setting display language, measuring unit, and probe zeroing.

Navigating the Function Catalog

Performing Basic Settings

Display Settings (Language, Contrast, Resolution)

Probe Setup and Calibration Procedures

Probe Positioning and Sensitivity Alignment

Steps for correctly positioning probes and aligning their sensitivity.

Calibrating a Measuring Channel

Procedure for calibrating individual measuring channels.

Feature Calculation and Display Settings

Setting Factor for Indicated Value Correction

Adjusting factors to correct indicated measurement values.

Channel Formulas and Feature Selection

Master Measurement Procedures

Master Measurement Types and Nominal Value Entry

Performing Master Measurement

Step-by-step guide for conducting master measurements.

Setting Tolerances and Limit Values

Setting Tolerance and Warning Limits

Configuring upper and lower tolerance and warning limits.

Plausibility Limits and Status Lamp Colors

Measurement Operations and Recording

Filter Parameters and Measuring Sequence

Operating Modes and Measured Value Memories

Performing Specific Measurements

Measurement Examples (Aggregate, Differential, Run-out)

Serial Interface (RS 232) Configuration

Protocol, Format, and Handshake Settings

Configuring serial communication parameters.

Transfer Rate and Data Transfer Initiation

Parallel (I;O) Interface Configuration

Pin Assignments and Digital Input;Output

Analog Output Configuration

Settings for analog output features and sensitivity.

Error Messages and Troubleshooting

Technical Data and Specifications

General and Electrical Specifications

Measuring Range and Probe Compatibility