Safety Instructions
This instrument complies with the relevant safety regulations. It was dispatched from
our production facility in good condition and perfect working order. However, failure
to follow the instructions given below can cause personal injury or death.
1. Before you connect up and use the equipment for the first time, read the ac-
companying documentation. Follow the safety precautions detailed in the op-
erating instructions.
2. Keep the documentation close to the equipment ready for quick reference.
3. Follow safety precautions, accident prevention regulations and internal com-
pany instructions. You should request further information from your company
safety officer.
4. Before you connect up the equipment, check the local supply voltage to make
sure that it is within the working range of the AC adapter (100 V - 240 V, 50 Hz
- 60 Hz). If they do not match, the instrument may not be connected under any
circumstances!
5. The instrument may only be connected to a grounded power socket which
complies with the regulations of the local power supply company. This also ap-
plies to any extension cables used.
6. Only use original, intact AC adapters.
7. When connecting inductive probes make sure that the plugs are firmly screwed
onto the connection sockets.
8. When connecting pneumatic probes make sure that the compressed air is con-
nected properly.
9. Do not drop the instrument and make sure it is positioned securely.
10. Do not operate the instrument in areas where there is a risk of explosion and
do not expose it to direct sunlight!
11. Do not clean the membrane keypad with cleaners that contain solvents.
12. Before opening the housing, disconnect the power supply.
13. The gages with which the Millimar is used are subject to gage monitoring.
For this reason, gage monitoring performed by the user or Mahr Service must
ensure adherence to the specified error limits.
To Next Page
Loading...
Need help?
General
