Mahr GmbH, Millimar C1208/C1216/1240
3.2 Setting the contrast
The contrast can be adjusted to the light condi-
tions of the location. On delivery, contrast is set
to medium. However, this can be changed at any
time. To do this:
1. Press the MENU key when the standard
display elements are shown. The catalog of
functions and parameters is opened and the
setting “FEATURE (1)” is displayed.
2. Use the DATA and MASTER keys to select
the setting “SETTING (4)”.
3. Press MENU again. The setting “DISPLAY
(4.1)” is displayed.
4. Press MENU again. The setting “FEATURE
(4.1.1)” is displayed.
5. Use the DATA and MASTER keys to select
the setting “CONTR. (4.1.3)”.
6. Press MENU again. Setting “CONT.+/-”
and the numerical value of the current con-
trast setting are displayed.
7. Use the DATA and MASTER keys to select
the new contrast (16, 13, .….., 1, 0).
The highest contrast setting is
“16” and the lowest “1”. When
“0” is selected, the display be-
comes blank. This setting is not
recommended!
8. Press START. The numerical value of the
contrast setting that has been selected flash-
es.
9. Press START again to adopt the flashing
contrast setting. The display then returns
to the catalog of functions and parameters
item “CONTR. (4.1.3)”.
If at this point either the DATA
or MASTER key is pressed in-
stead of START, the dis play
returns to the contrast set ting
selection list (cf. point 7). The
contrast can be changed again.
10. If no further settings are to be made in the
catalog of functions and parameters, press
the START key. The standard display ele-
ments appear.
If further settings are necessary, navigate
to the appropriate point of the catalog of
functions and parameters using the ESC,
MASTER, DATA and MENU keys and carry
out the settings as required.
To Next Page
Loading...
Need help?
General
