11. Press START twice as soon as the required
value was entered. The setting is adopted
and „S FACT.(4.7.3.2)“ displayed again.
12. If no further settings are to be made in the
catalog of functions and parameters, press
the START key. The standard display ele-
ments appear.
If further settings are necessary, navigate
to the appropriate point of the catalog of
functions and parameters using the ESC,
MASTER, DATA and MENU keys and carry
out the settings as required.
16 Restoring the factory settings
Pressing the ESC key immediately after switch-
ing on the unit initializes the instrument, restor-
ing all the original factory settings. This is indi-
cated by “INITALL” appearing on the display
during startup.
1. Hold down the ESC key when switching on
Millimar. The unit boots up and “INITALL”
is displayed. Once the boot-up process has
been completed “DEUTSCH (4.3.1)” flashes.
2. Use the DATA and MASTER keys to set the
display language and press START (twice)
to adopt the selected language. MM (4.4.1)
flashes.
3. Use the DATA and MASTER keys to set the
measuring unit and press START (twice) to
adopt the selected unit. “MAHR“ appears on
the display, followed by the standard display
elements.
To Next Page
Loading...
Need help?
General
