MAINTENANCE
The speed sensor electronics normally requires no maintenance, however a program of periodic checks
would be beneficial. The enclosure and circuit board should be cleaned if necessary, but only when the
power is disconnected using a vacuum cleaner and a clean dry paint brush. Check all electrical contacts for
corrosion and arcing.
The speed sensor bearing should be periodically checked for corrosion, wear and seizing. The bearings life is
dependent upon the mounting, the severity of the application and surrounding environment.
SPARE PARTS
Bearing Assembly: - MD 2000A
- MD 2000A SS
Speed Sensor Card - without encoder
- with encoder
PL-361 3
To Next Page
Loading...
