Milnor 76028CBW - General Content of the EC-Declaration of Conformity

Chapter 1. Machine Description, Identification, and Certification
PELLERIN MILNOR CORPORATION
Figure 1: Machine Data Plate
View of Data Plate (English text shown) Legend
.
1. Model number. See inside
the front cover of this
manual.
2. Data that uniquely
identifies your machine
3. Cylinder maximum
rotation speed in
revolutions per minute, if
applicable
4. Cylinder volume in the
units of measure shown,
if applicable
5. Piped utility requirements
6. Hydraulic oil pressure, if
applicable
7. Electrical requirements
8. Part number for multi-unit
machine, if applicable.
Supplement 1
About Machines With Multiple Data Plates
Machines shipped as multiple units for assembly on site (example: CBW tunnel washer) will
have multiple data plates—one for each unit and a master plate for the complete machine,
located on the primary unit. Although each unit can have a different model number, they will
all share the same basic serial number. The basic serial number is usually 8 digits. Some of the
units will have a two-digit suffix at the end of the serial number.
— End of BIUUUF01 —
BIPCUL01 (Published) Book specs- Dates: 20131211 / 20131211 / 20131211 Lang: ENG01 Applic: PCU
1.2. General Content of the EC-Declaration of Conformity
Manufacturer: Pellerin Milnor Corporation
Hereby we declare under our sole responsibility that the machinery
Type (see the declaration for your machine)
Serial no (see the declaration for your machine)
Manufacturing date (see the declaration for your machine)
is in conformity with the provisions of
2006/42/EC (17 May 2006) - Machinery
2004/108/EC (15 December 2004) - Electromechanical compatibility
2006/95/EC (12 December 2006) - Low voltage
Pellerin Milnor Corporation certifies that the machine(s) listed above, manufactured in Kenner,
Louisiana, 70063, USA conform(s) as stipulated by schedule of verification of
ISO 10472-1:1997 - Safety requirements for industrial laundry machinery - Part 1: Common
requirements
ISO 10472-3:1997 - Safety requirements for industrial laundry machinery - Part 3: Washing
tunnel lines including component machines
11