Figure 2. Bearing Housing Front
Legend
A. Detail view of the bearing housing front.
C. Apply anti-seize compound to the bolt.
D. Clean the shaft and the inner sleeve. Make sure that they are clean and free from oil. Apply adhesive, then the
sleeve. Make sure of a bond on a minimum of 75% of the surface.
E. Apply adhesive to the bolt.
F. Add shims to a thickness of .004 inches — .005 inches. The shaft must turn in the housing. For details of the rec-
ommended procedure, refer to the document MSSM0261AE.
G. Apply adhesive to the outer circumference of the seals. Let the adhesive dry 24 hours. Make sure that all surfaces
are clean and free from oil before you assemble.
H. Set the set screw to be flush with the outer edge of the seal holder.
K. The seal holders must be fully down before you tighten the fasteners.
L. When you change the seal holder, torque item 17 to 150 IN. LBS. This bolt has a nylon insert and a hole to let
grease to the water seals. Torque all remaining bolts to the standard torque.
Bearing Housing Components MWF27
2 of 4
BPWMAB03 / 2017502A
BPWMAB03 0000166675 B.2 12/11/17 3:34 PM Released
61
To Next Page
