Milwaukee 2237-20 User Manual (English)

Other manuals for Milwaukee 2237-20

Questions and Answers:

R
reevesjenniferJul 30, 2025
What to do if the LED for NCVD doesn’t light up on my Milwaukee 2237-20 Multimeter?
- L
  lbeckJul 30, 2025
  If the LED for NCVD (Non-Contact Voltage Detection) on your Milwaukee Multimeter doesn't light up, there are a few potential causes. First, check for breaks in the Flex PCB for Jaws; if there are any, replace the Jaws. Second, the NCVD LED orientation might be off; try adjusting the NCVD LED upward. Finally, a defect of circuit component might be the problem, in this case replace the PCB.
J
Jennifer OsbornAug 4, 2025
Why is the temperature measurement inaccurate on my Milwaukee 2237-20?
- C
  Christopher StephensAug 4, 2025
  If you are experiencing inaccurate temperature measurements with your Milwaukee Multimeter, it could be due to a couple of reasons. One possible cause is insufficient battery capacity. When the “BATT” mark is displayed on the LCD, replace the batteries. If the batteries aren't the issue, the PCB may need re-adjustment. If so, check the components and follow the adjustment procedure to re-adjust the PCB.
V
Vicki WadeAug 10, 2025
What to do if Milwaukee Multimeter function buttons are invalid?
- M
  Melinda RamirezAug 10, 2025
  If the function buttons on your Milwaukee Multimeter are not working correctly, it could be due to poor contact at the circuit components or a defect of circuit component. Try disassembling and cleaning the Function Buttons and the PCB to address poor contact. If that doesn't resolve the issue, consider replacing the PCB or Rubber Contact.
R
Randall GordonAug 17, 2025
Why is my Milwaukee 2237-20 Multimeter incapable of measurement at temperature range?
- L
  Leslie ClarkAug 17, 2025
  If your Milwaukee Multimeter is incapable of measurement at temperature range, it might be due to a defect in the Temperature Probe; in this case, replace the Temperature Probe. Alternatively, there may be a defect of circuit component, so replace the PCB.

Milwaukee 2237-20 Specifications

General

Category	Multimeter
Model	2237-20
Brand	Milwaukee
Display	LCD
Voltage Range	600V AC/DC
Current Range	10A AC/DC
Resistance Range	40 MΩ
Data Hold	Yes
Backlight	Yes
Auto Power Off	Yes
Continuity Test	Yes
Diode Test	Yes
Safety Rating	CAT III 600V
Low Battery Indicator	Yes
Weight	0.5 lbs
Operating Temperature	32° to 122°F (0° to 50°C)
Battery Type	AA