Need help?Do you have a question about the Milwaukee M12 FUEL 2526-20 and is the answer not in the manual?
General| Voltage | 12V |
|---|---|
| Battery Compatibility | M12 |
| Power Source | Cordless |
| Motor Type | Brushless |
| Battery System | M12 |
| Battery Type | Lithium-ion |
| Tool Only | Yes |
| Chuck Type | 1/4" Hex |
Keep work area clean and well lit. Avoid explosive atmospheres. Keep bystanders away.
Use correct plugs, avoid earthed surfaces, protect from rain/wet, don't abuse cords, use outdoor/GFCI cords.
Stay alert, use PPE, prevent unintentional starting.
Use correct tool, don't force it, repair if switch fails, disconnect power before adjustments.
Recharge with specified charger, use only designated battery packs.
Push release buttons, pull pack away. Slide pack into body, ensure secure latch.
Remove battery, lift lever, push forward, unscrew bolt, attach accessory, tighten, replace lever.
Check battery charge level. Lights indicate remaining power and low battery.
Rotate speed dial to set OPM from 10,000 to 20,000.
Slide switch to ON (I) to start, wait for full speed. Slide to OFF (0) to stop.
Lists typical applications like sawing/cutting, scraping, sanding.
Regular maintenance, inspect for noise/misalignment/breakage. Service/inspect tool periodically.
Clean vents, handles. Use mild soap and damp cloth. Avoid solvents.
Return tool, battery, charger to authorized service center for repairs.
Use only recommended accessories. Others may be hazardous.
To Next Page