To Next Page
L
Lydia CollierJul 25, 2025
What to do if the flow rate is too low on my Milwaukee Water Pump?
- MMiranda CareyJul 25, 2025
If the flow rate of your Milwaukee Water Pump is too low, there might be several reasons. The inlet or outlet line could be clogged or damaged, in which case you should replace it. Alternatively, the inlet connection may not be airtight; try tightening it, and use Teflon tape or a gasket if needed. Also, check that the impeller cover is secured tightly by hand-tightening the four cover screws. Finally, the impeller might be worn out and need replacement.
General
