Milwaukee M18 - Page 12

n XXXX min-1
Impacts per Minute Under Load (IPM)
UL Listing for Canada and U.S.
SPECIFICATIONS
Volts…………………………………………………….. 18 DC
Battery Type ………………………………………….M18™
Charger Type…………………………………………M18™
Recommended Ambient
Operating Temperature………………….0°F to 125°F
Cat. No……………………………………………… 2656-20
RPM……………………………………………………. 0-2750
IPM …………………………………………………….. 0-3450
Cat. No……………………………………………… 2657-20
RPM…………………………. High 0-2750 Low 0-2000
IPM ………………………….. High 0-3450 Low 0-2450
Cat. No……………………………………………… 2658-20
RPM……………………………………………………. 0-2450
IPM …………………………………………………….. 0-3350
Cat. No……………………………………………… 2659-20
RPM……………………………………………………. 0-2450
IPM …………………………………………………….. 0-3350
FUNCTIONAL DESCRIPTION
Cat. No. 2657-20
Cat. No. 2658-20
Cat. No. 2659-20
1. 1/4″ Hex drive chuck (2656-20, 2657-20)
2. LED
3. Control switch
4. Trigger
5. Speed control (2657-20)
6. Belt clip
7. Handle
8. 3/8″ Square drive anvil (2658-20)
9. 1/2″ Square drive anvil with pin detent (2659-20)
ASSEMBLY
WARNING Recharge only with the charger specified for the battery. For specific charging instructions, read the
operator’s manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons and pull the battery pack away from the tool.
WARNING Always remove battery pack before changing or removing accessories.
To insert the battery, slide the pack into the body of the tool. Make sure it latches securely into place.
WARNING Only use accessories specifically recommended for this tool. Others may be hazardous. Use only sockets
and other accessories specifically designed for use on impact wrenches and drivers. Other sockets and accessories
might shatter or break causing injury.
Attaching and Removing Accessories
1/2″ Impact Wrench with Pin Detent
(Cat. No. 2659-20)