purchased the product, to the Authorized Service Center (ASC). Or, if this card has not been sealed/stamped,
present the original proof of purchase to the ASC.
Call 55 4160-3547 to find the nearest ASC, for service, parts, accessories or
components.
Procedure to make this warranty valid
Take the product to the ASC, along with the warranty card sealed/stamped by the distributor or store where you
purchased the product, and any faulty piece or component will be replaced without cost for you. We will cover all
freight costs relative with this warranty process.
Exceptions
This warranty is not valid in the following situations
a) When the product is used in a different manner from the end-user guide or instruction manual.
b) When the conditions of use are not normal. c) When the product was modified
or repaired by people not authorized by TECHTRONIC INDUSTRIES. Note: If cord set is damaged, it should be
replaced by an Authorized Service Center to avoid electric risks.
SERVICE AND ATTENTION CENTER
Call to 55 4160-3547
IMPORTED AND COMMERCIALIZED BY
TECHTRONIC INDUSTRIES MEXICO, S.A. DE C.V.
Miguel de Cervantes Saavedra No.301 Piso 5, Torre Norte
11520 Colonia Ampliación Granada
Miguel Hidalgo, Ciudad de Mexico, Mexico
Model: ______________________________
Date of Purchase: _____________________
Distributor or Store Stamp:
MILWAUKEE TOOL
13135 West Lisbon Road
Brookfield, WI 53005 USA
58142613d5
01/20
961012795-02(A)
Printed in Vietnam
SERVICE PARTS LIST
BULLETIN NO.
54-26-2503
EXAMPLE:
Component Parts (Small #) Are Included When Ordering The Assembly (Large #).
*= Part number change from previous service parts list.
As an aid to assembly, carefully lower the complete front end of tool (gearcase / impacting system) onto the gearcase
end cap (with o-ring installed). Gently press front end assembly onto gearcase end cap. Be careful to apply pressure
evenly and squarely by hand.
NOTE: Components of the impacting assembly (58) can drop out of the gearcase (54). Care must be taken to hold
those elements in place when assembling onto the gearcase end cap (24).
Rubber Slugs are (4x) per handle halve (8x total)
FIG. LUBRICATION
(Type ‘J’ Grease, No. 49-08-4220):
10 Lightly coat front washer surface of anvil (10) with grease, place a dab in the ball holes of anvil.
22,58 Lightly coat the I.D. of the ring gear (22) and the center of the planet gears of impacting assembly with grease.
To Next Page
Loading...
