ix
WARNING
Do not disassemble or remodel the plotter. Handling of the power cable
• Never disassemble or remodel the plotter.
Disassembly or remodeling can result in an
electric shock or breakdown of the
machine.
• Use the supplied power cable. Take care
not to damage, break or work upon the
power cable. If a heavy material is placed
on the power cable, or if it is heated or
pulled, the power cable can break, thus
resulting in fire or electric shocks.
Avoid locating the plotter in a damp environ-
ment.
In case abnormal event occurs.
• Do not use the plotter in a damp place. Do
not splash water onto the machine. Use in
such an environment can give rise to fire,
electric shocks or breakdown of the plotter.
• Use of the plotter under an abnormal condi-
tion where the device produces smoke or
strange smell can result in fire or electric
shocks. If such an abnormality is found, be
sure to turn off the power switch immedi-
ately and unplug the cable from the wall
outlet. Check first that the plotter no longer
produces smoke, and contact your distribu-
tor for repair.
• Never repair your plotter by yourself since it
is very dangerous for you to do so.
CAUTION
A place exposed to direct sun-
light
On an inclined surface A place where temperature or
humidity varies significantly
• Use the plotter under
the following environ-
mental conditions:
• Operating environment:
20 to 35°C
35 to 65% (Rh)
A place that vibrates A place exposed to direct air
flow from an air conditioner or
the like.
Around a place where flame is
used
To Next Page
Loading...
