Mimaki Europe B.V.
Sign Graphics Products
• Over cut
• By overlapping the start and the end point, cutting is done without uncut parts.
• Effective when cutting thick or sticky media as well as the ones easy to bend
• Corner cut
• The edge of the blade overlaps at other corners.
• By using Corner cut, the corners are cut sharp
39
1.0mm
1.0mm
When the length of the over cut is set, cutting is performed from the position before the starting
point by the specified length and stops after crossing the end point.
Setting value: 0.1mm – 1.0mm
Over cut Corner Cut
1.0mm
1.0mm
A wide variety of Print&Cut functions
To Next Page
Loading...
