STEP 5
STEP 5
5-1. Open the door of tank housing.
5-2. Attach the regulator to the gas cylinder and tighten with wrench if
fitted with a nut, or tighten by hand if fitted with a hand wheel.
5-3. Unscrew the igniter button, then install the battery and tighten
igniter button.
5-4. Then leak test the gas inlet and gas cylinder connections as explained
on page 4.
5-5. Put the gas cylinder into the tank housing, then close the door.
Note:
The ignitor is powered by a small battery, if the pilot can’t
be lighted, the problem may be the battery which is exhausted.
Please replace the battery(DC 1.5V).
AAA Battery (1.5 V)
Page 10
To Next Page
Loading...