What to do if the Mimosa 0151858 Gas Heater pilot will not light?
If the pilot light on your Mimosa Gas Heater won't ignite, there could be several reasons. The gas valve might be OFF, so turn it ON. The tank fuel could be empty, in that case purge air from the pilot gas line. There might be air in the supply system, so check all fittings. Also, service pilot as shown in this manual. Check all fittings.
Why burner will not stay on in my Mimosa Gas Heater?
The burner on your Mimosa Gas Heater might not stay on due to several reasons: loose connections (service pilot as shown in this manual), a bad thermocouple (tighten connections), or a gas leak in the line (check connections).
What to do if Mimosa Gas Heater has gas leak at inlet connection?
If there's a gas leak at the inlet connection of your Mimosa Gas Heater, it's likely due to a damaged or deteriorated O-ring seal. Fit a new O-ring to resolve this issue.
Why is the burner flame low on my Mimosa 0151858 Gas Heater?
If the burner flame on your Mimosa Gas Heater is low, it could be because the supply hose is bent or twisted. Straighten the hose and then perform a leak test on it.
What to do if Mimosa 0151858 emits thick black smoke?
If your Mimosa Gas Heater is emitting thick black smoke, turn it off and allow it to cool down, as this indicates a blockage in the burner.
How to fix uneven glow of emitter on Mimosa Gas Heater?
An uneven glow from the emitter on your Mimosa Gas Heater can be caused by low gas pressure. Replace the cylinder with a new one. Alternatively, the base might not be on a level surface, so place the heater on a level surface.
How to remove carbon build-up on Mimosa Gas Heater?
Carbon build-up on your Mimosa Gas Heater is likely due to dirt or film on the reflector and flame screen. Clean the reflector and flame screen to resolve this.
General| Model | 0151858 |
|---|---|
| Category | Gas Heater |
| Power Source | Propane |
| Color | Black |
| Material | Steel |
| Safety Features | Tip-over safety shutoff, Overheat protection |
| Warranty | 1-year limited warranty |
Ensures safe operation by specifying ground, environmental, and ventilation requirements for heater placement.
Details on acceptable enclosure types and ventilation requirements for safe outdoor heater use.
Illustrates acceptable outdoor enclosure configurations based on wall openings and ventilation.
Guidelines for storing the heater and gas cylinder safely after use or when not in operation.
Details on the heater's dimensions, materials, gas consumption, and certifications.
To Next Page