Mimosa Backhaul Help Content
Mimosa Backhaul Troubleshooting Guide
Copyright © 2014 Mimosa Page 206
Confirm that Tx power is set the same on both channels (Wireless > Channel & Power > Tx Power 1 and Tx
●
Power 2). This may not be possible depending on channel selection options within your regulatory domain
because some frequency ranges have different EIRP limits. A workaround is to choose two channels with the
same EIRP restrictions.
Verify that the frequency of the low power channel is supported by the antenna. Consult the antenna datasheet
●
for supported frequencies.
Related:
Backhaul Troubleshooting: Low SNR - Troubleshooting steps for low signal-to-noise ratio
Backhaul Troubleshooting: High PER - Troubleshooting steps for high packet error rate
Backhaul Installation: RF Tuning Process - Overview of how to tune a Mimosa Backhaul link.
To Next Page
Loading...