SAFETY
1. Dangerous high voltages are present inside the case. Always cut
power to the controller before opening the front cover.
Installation of a nearby power cutoff switch is recommended.
2. Contact Minco before attempting any repairs.
3. Do not remove the CT124’s rear cover. Access the inside by
removing the front cover only.
4. Many components may be damaged by static discharge. Do not
touch electrical connections inside the case. Handle plug in cards
only by their edges or at a static-free workstation.
5. Never unplug the ribbon cable inside the enclosure while power
is applied. Permanent damage may result.
Minco Products, Inc. CT124 Instruction Manual
2
To Next Page
Loading...
