EasyManua.ls Logo

mind alive DAVID PAL36 - CES Operating Instructions

mind alive DAVID PAL36
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 14
will flash to show an error. Turn the PAL36 with CES off at the end of
your session to preserve your battery. To replace the battery, slide battery
compartment cover off and place battery as shown in Figure 3 (page 10).
Place the bottom of the battery down into the compartment first and then
push the top down against the metal clips. An alkaline 9-volt battery will
provide approximately seven hours of operation.
To Record or Clear Session History
Each time you play a preset session, the session number will be stored in
the PAL36 with CES, so that you can have faster access to the last three
sessions selected. To clear these sessions, press VOL while the PAL36
with CES is scrolling for a session to be selected. This will erase or clear
the session history.
Downloading/Erasing a Session
Your DAVID PAL36 with CES is programmable. There are six blank
sessions (C1 to C6 in Library 2) for storing additional sessions. All of the
preset sessions may be reprogrammed or erased. To add or change
sessions, you will need the DAVID Session Editor. The PAL36 with CES
may also be programmed automatically from an encoded CD (eg. Special
Application Sessions). Refer to the DAVID Session Editor help file for
design and download instructions.
CES OPERATING INSTRUCTIONS
CES will only operate while an AVE session is running. The rate of the
stimulus is synchronized with the AVE. When using CES by itself you
can operate it while sitting, lying down or engaged in a quiet, non-
hazardous activity such as a relaxing walk.
To use the CES, turn the intensity slider to lowest setting (far left). Insert
the CES stimulus cable into the CES OUTPUT jack.
Attach the yellow clip to the left earlobe and the blue clip to the right
earlobe. For better conductance, we recommend putting a small amount
of water or saliva on the earlobes.
Slide the intensity slider to the right slowly until a very mild sensation is
felt. Setting the intensity too high may result in skin irritation.
After a few minutes, you may notice that the intensity of the stimulation
is stronger. Reduce the intensity. It is not necessary to feel the sensation
to get results. At the end of the session, turn the intensity down and
remove the clips from the earlobes.